Our flagship tool since 2012: a USB interface and Windows software for programming and repairing car control units, at the bench or directly through the OBD port. Repair cars by reusing ECUs instead of replacing them.

• Read and write EEPROM and FLASH, clone one unit to another, reset or remove the immobiliser.
• PIN and card code recovery, odometer and VIN correction, DTC clearing, checksum correction.
• Engine ECUs, body computers, ABS, radar, radio and RF units, with a strong focus on FCA and Opel.
• K-line and CAN over one USB 2.0 interface. Body computers read directly by OBD, no dismounting.
• Digitally signed drivers. Runs on Windows from XP SP3 to 11.